RFL 9300 RFL Electronics Inc.
September 5, 2007 xvii (973) 334-3100
REVISION RECORD
Rev Description Date Approval
06-15-97
New Document Release (updated manual to three-terminal opera-
tion)
06-15-97
CS
10-01-97
Sections 2, 3 and 4 revised in accordance with new engineering
Documentation
10-01-97
CS
12-15-97
Sections 6 and 8 revised in accordance with new engineering
documentation, Added time-overcurrent parameters.
12-18-97
CS
04-15-98
Added Time Overcurrent function to Sections 6 and 8.
Added warning “to prevent potential mis-operation” to the first
page of Section 8.
09-16-98
CS
05-01-98
Added solid front panel, Added new product information sheet
(Section 1), Added new relay I/O module, Added ne section on
expansion chassis, Deleted sections on double width modules,
Deleted all references to vertical mount chassis, Updated glos-
sary, and other miscellaneous corrections.
10-21-98
CS
11-30-98
Added new Section 22 on Short Haul Fiber Interface module
and Fiber Service Unit. Shifted existing Sections 22 through 27 up
by one section number to Sections 23 through 28.
11-30-98
CS
03-26-99
Revised in accordance with ECO No. 9300-160 as follows:
Added new pre-fault buffer switching algorithm, added new stub-
bus function, synchronized clock to line frequency, and revised trip
release algorithm to improve security.
04-03-99
CS
02-07-00
Revised in accordance with ECO No. 9300-208 (200ms limit, re-
vised Section 2). Revised in accordance with RFA No. 6569 (Up-
dated Section 22). Added new Section 23 (G.703 Interface I/O),
added new Section 24 (Single Pole Tripping) and shifted existing
Sections 23 through 28 up by two section numbers to Sections 25
to 30. Added Table 2-1, Valid Hot-Standby Configurations.
05-17-00
CS
08-25-00
Revised Sections 0, 1, 2, 3, 4, 6, 8, 9, 10, 24 and 25 in accor-
dance with new software documentation. Revised in accordance
with ECO Nos. 9300-220, -225 and –226.
08-25-00
CS
10-27-00
Revised Sections 0, 6, 7, 8, 9, and 27 in accordance with new en-
gineering documentation.
10-27-00
CS
To Next Page
Loading...