RFL Electronics RFL 9300 - Page 476

30 Local Alarm From Supervisor Module: Local Charge Comparison Trip without fault detector
- ground subsystem.
31 Local Alarm From Supervisor Module: Local Charge Comparison Trip without fault detector
- Phase A.
32 Local Alarm From Supervisor Module: Local Charge Comparison Trip without fault detector
- Phase B.
33 Local Alarm From Supervisor Module: Local Charge Comparison Trip without fault detector
- Phase C.
34 Local Alarm From Supervisor Module: Parallel Port Alarm.
35 Local Alarm From Supervisor Module: Software Mismatch Alarm.
37 General Alarm: Remote #1 Configuration Mismatch.
40 Reserved for future use.
41 Reserved for future use.
42 Reserved for future use.
43 Reserved for future use.
44 Reserved for future use.
45 Local Alarm: Open Conductor Alarm.
46 General Alarm: Systems Communications Alarm.
47 General Alarm: Remote #2 Configuration Mismatch. (This alarm code is not present in two ter-
minal systems)
54 Single-Pole Logic: General Alarm (This alarm code is only present in single-pole systems)
55 Single-Pole Trip Alarm: Phase A DC trip current sensed for more than 500ms (This alarm code
is only present in single-pole systems)
56 Single-Pole Trip Alarm: Phase B DC trip current sensed for more than 500ms (This alarm code
is only present in single-pole systems)
57 Single-Pole Trip Alarm: Phase C DC trip current sensed for more than 500ms (This alarm code
is only present in single-pole systems)
60 Phase A Controller: General Alarm
61 Phase B Controller: General Alarm
62 Phase C Controller: General Alarm
63 3I0 Controller: General Alarm
When all alarms are cleared, the display will return to the moving dot pattern, and the beeper will stop sounding.
RFL 9300 RFL Electronics Inc.
May 5, 2002 28 - 2 (973) 334-3100