Roll Feeder (D503/D504)
D093/D094 3-38 SM
12. Attach the right joint bracket [1] (the spindle [2] must go through the hole). At the same time,
align the plate with the holes for the three screws (blue).
The joint brackets and screws are provided as accessories with the roll feeder.
13. Attach screws
, but do not tighten them.
14. While you lift the main machine by its handle [3], set screw
in the lower hole of the
keyhole cutout and tighten it.
15. Tighten screws
and .
16. Do the above procedure again for the left joint bracket [4].
When you attach the left bracket make sure that the bracket does not pinch or
interfere with the harness of the main switch.
To Next Page
Loading...
