Ricoh D093 - Page 117

Roll Feeder (D503/D504)
SM 3-39 D093/D094
Installation
 The guide plate and screws are provided as accessories with the roll feeder.
17. Install the guide plate [1] (
x 2 Blue). Hang the hooks on each end (this positions the plate
for installation).
 The movable guide plates are provided as accessories with the roll feeder.
18. Attach the movable guide plates [1] (x6).
 Each plate is the same. It is not possible to install a plate in the incorrect position.
 Attach each plate with the ribbed side down.
 Move the hinges [2] a small distance apart. This allows the tabs attach easily into the
holes.
19. Lift each plate and let it fall, to make sure that they move smoothly on the hinges.
20. Reattach the manual feed table.
21. Reattach the left and right covers.
 The flat-head screw must be attached at the rear side of each cover.
22. Close the upper unit.