SP1-xxx Feed
SM Appendix 2-5 D093/D094
Appendix:
SP Mode
Tables
5
Feed Motor : Cut Paper Tray DFU
[-30 to +30/0/1]
For every change of "1", speed is adjusted approximately 0.094%.
6
Main Motor DFU
[-80 to +80/0/1]
For every change of "1", speed is adjusted approximately 0.04%.
7
Fusing Motor DFU
[-100 to +100/7/1
For every change of "1", speed is adjusted approximately 0.054%.
1910 Motor Speed Adjustment
This SP adjusts the speed of the roll feed motor for feeding plain roll paper,
translucent roll paper, and film roll paper.
1 Feed Motor: Roll: Plain Paper [-100 to 100 / -10 / 1]
2 Feed Motor: Roll: Translucent Paper [-100 to 100 / 0 / 1]
3 Feed Motor: Roll: Film [-100 to 100 / -10 / 1]
1911 By-pass Feed Start Timing
Adjusts the time that the operator has to adjust the paper skew manually when
feeding paper manually from the bypass tray..
[1.0 to 8.0/2.0/0.1 sec.]
1912 Registration (Main Motor) Motor Speed-up
This SP can increase the speed of the main motor just before the trailing edge of
the paper leaves the nip of the registration rollers.
Normally, the speed of the fusing roller is slightly faster than the speed of
the registration roller in order to pull the paper taut and stabilize paper feed.
However, this small difference in speed between the rollers can cause jitter
when the trailing edge of the paper leaves the nip of the registration rollers.
To Next Page
Loading...
