SP1-xxx Feed
D093/D094 2-6 SM Appendix
In order to prevent this jitter, just before the paper leaves the registration
roller the speed of the registration roller can be increased slightly to match
the speed of the fusing roller.
[0 to 125 / 0 / 1]
1915 Motor Speed Adjustment
The fusing roller rotates slightly faster than the registration roller in order to keep
the paper taut in the paper path. In some cases, this can cause "jitter" when the
trailing edge is released by the registration roller. To correct this problem, this SP
can be set to reduce the speed of the fusing roller just before the trailing edge of
the paper is released by the registration roller in order to reduce the effect of the
trailing edge snapping away from the registration roller.
[-5 to 0 / 0 / 0.02 %]
1916 Fusing Motor Speed Adj.
SP1916 10 to 013 adjust the basic fusing motor speed and correct the speed for
different widths of paper to prevent skew in the paper feed path.
Note:The actual adjustment that the machine applies is the sum of the width
adjustment (1916 010 to 013) and the paper type adjustment (1916 021 to 045).
10 Width:611mm more [-100 to +100/0/1]
11 Width:461-610mm [-100 to +100/5/1]
12 Width:298-460mm [-100 to +100/9/1]
13 Width:297mm less [-100 to +100/18/1]
Note: “Mode 1 to 5” below refer to the paper thickness set with [User Tools]>
"System Settings"> "Tray Paper Settings"> "Paper Thickness: Paper Tray" or
"Paper Thickness: Bypass Tray".
21 Plain:Mode1
[-100 to +100/0/1]
22 Plain:Mode2
23 Plain:Mode3
24 Plain:Mode4
To Next Page
Loading...
