SP1-xxx Feed
D093/D094 2-28 SM Appendix
23 Paper Interval Step 3
When the pressure roller center and end thermistor detect a temperature in the
Step 3 range (SP1940 013), the setting of this SP is activated to set the length of
the interval between sheets in the paper path.
[1.0 to 5.0/3.5/0.1]
The default setting (3.5) is the variable for Step 3 multiplied by the constant set
for Step 2 of the machine:
D093: 480 mm. The default interval is 1680 mm (3.5 x 480 mm).
D094: 168 mm. The default interval is 588 mm (3.5 x 168 mm).
Setting a smaller or larger number decreases or increases the length of the
interval with this simple calculation. This standard interval can be modified
slightly with SP1923.
51 Enable II
When the temperature of the hot roller drops during continuous printing, the
machine enters the CPM down mode to increase the distance between sheets of
paper going through the fusing unit. The slightly longer wait time between the
trailing edge of the sheet going through the fusing unit and the leading edge of
the next sheet, gives the hot roller more time to recover optimum temperature.
This SP switches CPM Down Control II.
[0 to 1 / 1 / 1]
Note: The size of the interval between sheets in the paper path can be adjusted
with SP1940-062.
61 Paper Interval Step 2 II
When the temperature of the hot roller drops during continuous printing, the
machine enters the CPM down mode to increase the distance between sheets of
paper going through the fusing unit. This SP adjusts the size of the interval
between sheets in the paper path after CPM Down Control II has been switched
on with SP1940-51 (Enable 2).
[1 to 10 / 2.9 / 0.1]
Note: The size of the interval is adjusted for Step 3 II with SP1940-62.
To Next Page
Loading...
