SP2-xxx Drum
SM Appendix 2-43 D093/D094
Appendix:
SP Mode
Tables
sensor becomes available.
After the ID sensor has been replaced, reset the SP to 0.
5 Long Print: Drawing
The machine switches to the Long Print mode (fixed toner supply mode) for any
original longer than 1189 mm (46.8 in.).
There are two Long Print modes (Long Print/Drawing and Long Print
Graphic).
If the operator is frequently running jobs that contain either a lot of lines or
graphics then SP2208-7 (Long Print Mode Setting) should be set
accordingly.
The values set for this SP are reflected in the printed images after Long
Print/Graphic has been selected.
[1 to 40 / 3 / 1%]
6 Long Print: Graphic
The machine switches to the Long Print mode (fixed toner supply mode) for any
original longer than 1189 mm (46.8 in.).
There are two Long Print modes (Long Print/Drawing and Long Print
Graphic).
If the operator is frequently running jobs that contain either a lot of lines or
graphics then SP2208-7 (Long Print Mode Setting) should be set
accordingly.
The values set for this SP are reflected in the printed images after Long
Print/Graphic has been selected.
[1 to 40 / 6 / 1%]
To Next Page
Loading...
