SP2-xxx Drum
D093/D094 2-44 SM Appendix
7 Long Print: Mode Setting
The machine switches to the Long Print mode (fixed toner supply mode) for any
original longer than 1189 mm (46.8 in.).
[0 to 1/0/1]
0: Drawing
1: Graphic
This SP can be set for the graphic or line mode, depending on which type of
job is most frequently required for printing.
For a Long Print mode job the setting of SP2208-5 is reflected when the
operator selects graphic mode, and the setting of SP2208-6 is reflected
when the operator selects line mode.
2301 Transfer Current Adjustment
Use these SP's to adjust the power output and power coefficient used to transfer
the toner image from drum to paper. Four separate voltages are applied before
the leading edge, at the leading edge of the paper, across the image area and at
the trailing edge of the paper..
Notes:
The coefficient adjustment should be done before the power output.
The amount of voltage applied to each area can be set independently in
each area for the type of paper in use.
To Next Page
Loading...
