SP2-xxx Drum
D093/D094 2-56 SM Appendix
2923 Execute Cleaning Blade Replace Mode
Always do this SP after replacing the OPC or cleaning blade.
This SP applies a small amount of toner to the drum and blade to reduce
friction between the new drum and/or new blade. This prevents scratching the
drum or bending the blade.
2924 Developer Mixing
1 Warmup
Prevents the occurrence of dirty background on the first copy after the machine
is switched on, or returns from the auto off mode or sleep mode.
[0 to 3/1/1]
0: Off
1: On (50 sec.). Development motor rotates 50 sec. after the machine is
switched on when fusing temperature is less than 50°C (122°F).
2: On (30 sec.). Development motor rotates 30 sec. after the machine is
switched on when fusing temperature is less than 50°C (122°F).
3: Development motor rotates 50 sec., regardless of the current fusing
temperature.
2 Enable
If the upper unit remains open for a long time, external light can sometimes
temporarily fatigue the drum and cause horizontal banding in prints. To solve
this problem, set this SP to "1" so as soon as the upper unit is closed, the
charge corona can apply a charge to the drum to correct the problem.
[0 to 1/1/1]
0: OFF
1: ON
To Next Page
Loading...
