10.31
Date Code 20171006 Instruction Manual SEL-400 Series Relays
Testing, Troubleshooting, and Maintenance
Technical Support
Step 5. Make all necessary connections to the module.
Step 6. If in Step 1 you chose to disconnect power, apply power to the Axion
module and then skip to Step 8. Otherwise, proceed to Step 7.
Step 7. Cycle power to the SEL relay.
Step 8. When startup is complete, press and hold the COMMISSION button on
the back of the relay for two seconds for the relay to verify the con-
nected topology.
Technical Support
We appreciate your interest in SEL products and services. If you have questions
or comments, please contact us at:
Schweitzer Engineering Laboratories, Inc.
2350 NE Hopkins Court
Pullman, WA 99163-5603 U.S.A.
Tel: +1.509.338.3838
Fax: +1.509.332.7990
Internet: selinc.com/support
Email: info@selinc.com
Figure 10.21 Axion Retaining Screw
To Next Page
Loading...
