B.14
SEL-421 Relay Instruction Manual Date Code 20171021
Converting Settings From SEL-421-0, -1, -2, -3 to SEL-421-4, -5
DNP3 Mapping Changes
Binary Outputs
Indexes 0–127 used to map the CCIN bits. These were general-purpose, high-
speed bits, but they are no longer available. The end user will need to remap these
to remote bits.
Table B.13 describes the mapping for the remaining bits.
Table B.13 Binary Outputs Mapping for DNP3 LAN/WAN (Sheet 1 of 2)
Numeric Reference Label Reference Notes
128 RB01
129 RB02
130 RB03
131 RB04
132 RB05
133 RB06
134 RB07
135 RB08
136 RB09
137 RB10
138 RB11
139 RB12
140 RB13
141 RB14
142 RB15
143 RB16
144 RB17
145 RB18
146 RB19
147 RB20
148 RB21
149 RB22
150 RB23
151 RB24
152 RB25
153 RB26
154 RB27
155 RB28
156 RB29
157 RB30
158 RB31
159 RB32
160 RB01:RB02
161 RB03:RB04
162 RB05:RB06
To Next Page
Loading...
