14.62
SEL-400 Series Relays Instruction Manual Date Code 20171006
ASCII Command Reference
Command Description
A sample VER command response is shown in Figure 14.11.
If an item is not installed, the VER report indicates Not installed at the appro-
priate line. If a detected hardware configuration does not match the component
part number, the relay adds the statement
Warning - hardware does not match
part number
on the corresponding line.
VIEW
Use the VIEW command to examine data within the relay database. You can
view these data in three ways:
➤ Region
➤ Register item
➤ Bit
The VIEW command in the relay is very similar to the VIEW command in SEL
Communications Processors. See Section 10: Communications Interfaces in the
product-specific instruction manual for more information on the relay database
regions and data types.
Typical relay regions are LOCAL, METER, DEMAND, TARGET, HISTORY,
BREAKER, STATUS, and ANALOGS; view this list with the MAP 1 command.
The relay is Virtual Device 1; all commands begin with VIEW 1. In all database
views, if a data item is in test mode (controlled by TEST DB command), the
relay displays an asterisk (*) mark following the data value.
=>VER <Enter>
FID=SEL-411L-R101-V0-Z013012-D20101111
CID=B66B
Part Number: 0411L5415XC0X4H343XX22
Serial Number: 2010123234
SELboot:
BFID= SLBT-4XX-R205-V0-Z001002-D20100128
Checksum: A92C
Mainboard:
Code FLASH Size: 12 MB
Data FLASH Size: 52 MB
RAM Size: 32 MB
EEPROM Size: 128 kB
Front Panel: installed
Analog Inputs:
W: Currents: 5 Amp
X: Currents: 5 Amp
Y: Voltage: 67 Volts
Z: Voltage: 67 Volts
Interface Boards:
Board 1: 24 inputs 8 outputs
Board 2: not installed
E4 Configuration: 0
Extended Relay Features:
IEC 61850
If the above information is not as expected, contact SEL for assistance.
=>
Figure 14.11 Sample VER Command Response
To Next Page
Loading...
