Parameter Description Unit
ZC3 Chuck dimension, counter-spindle (inc) - only for a counter-spindle that has been set-
up
mm
ZS3 Stop dimension, counter-spindle (inc) - only for a counter-spindle that has been set-
up
mm
ZE3 Jaw dimension, counter-spindle (inc) - only for a counter-spindle that has been set-
up and "Jaw type 2"
mm
XR Tailstock diameter - only for tailstock that has been set-up mm
ZR Tailstock length - only for tailstock that has been set-up mm
Setting up the machine
4.9 Monitoring axis and spindle data
Turning
Operating Manual, 06/2019, A5E44903486B AB 129
To Next Page
Loading...
Need help?
General
