You exit the edit mode by pressing the <SHIFT + INSERT> key combi‐
nation.
- OR -
You are in the edit mode and press the <INPUT> key.
A new line is created after the cursor position.
9.15.6 Compatibility for cycle support
The cycle support is generally upwards compatible. This means that cycle calls in NC programs
can always be recompiled with a higher software version, changed and then run again.
When transferring NC programs to a machine with a lower software version, it cannot be
guaranteed, however, that the program will be able to be changed by recompiling cycle calls.
Creating a ShopTurn program
9.15 Calling technology functions
Turning
Operating Manual, 06/2019, A5E44903486B AB 321
To Next Page
Loading...
Need help?
General
