Note
Copy/cut current line
To copy and cut the current line where the cursor is positioned, it is not necessary to mark or
select it. You have the option of making the "Cut" softkey only operable for marked program
sections via editor settings.
See also
Opening additional programs (Page 185)
Editor settings (Page 186)
Keys of the operator panel (Page 30)
6.10.4 Renumbering a program
You can modify the block numbering of programs opened in the editor at a later point in time.
Precondition
The program is opened in the editor.
Procedure
1. Press the ">>" softkey.
A new vertical softkey bar appears.
2. Press the "Renumber" softkey.
The "Renumbering" window appears.
3. Enter the values for the first block number and the increment to be used
for numbering.
4. Press the "OK" softkey.
The program is renumbered.
Note
● If you only want to renumber a section, before the function call, select the program blocks
whose block numbering you want to edit.
● When you enter a value of "0" for the increment size, then all of the existing block numbers
are deleted from the program and/or from the selected range.
Machining the workpiece
6.10 Editing a program
Turning
Operating Manual, 06/2019, A5E44903486B AB 183
To Next Page
Loading...
Need help?
General
