13.15.5 Delete multitool
Procedure
1. The tool list is opened.
2. Position the cursor on the multitool that you wish to delete.
3. Press the "Delete multitool" softkey.
The multitool with all of the tools that are located in it is deleted.
13.15.6 Loading and unloading multitool
Procedure
1. The tool list is opened.
Load a multitool into the magazine
2. Position the cursor at the multitool that you wish to load into the
magazine.
3. Press the "Load" softkey.
The "Load to" window opens.
The field "... Locat." is initialized with the number of the first empty
magazine location.
4. Press the "OK" softkey to load the multitool to the recommended
empty location.
- OR -
Enter the location number you require and press the "OK" softkey.
The multitool together with the tools in it is loaded to the specified
magazine location.
Loading a multitool into a magazine
2. Position the cursor on the required empty magazine location.
3. Press the "Load" softkey.
The "Load with." window opens.
4. Select the required multitool.
5. Press the "OK" softkey.
Tool management
13.15 Working with multitool
Turning
770 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
