Siemens SINUMERIK 840D sl Turning - Programming Example: Machining Counter-Spindle - Transfer Workpiece - Machining Main Spindle; Programming Example: Machining, Counterspindle - Without Previous Transfer

Programming steps - alternative 1:
● Machining, main spindle
● Gripping
● Withdrawing
● Counter-spindle machining side
● Machining, counter-spindle
Programming steps - alternative 2:
● Machining, main spindle
● Counter-spindle complete transfer (gripping, withdrawing and machining side)
● Machining, counter-spindle
10.7.17.2 Programming example: Machining counter-spindle – Transfer workpiece – Machining
main spindle
The programming for this operation might look like this:
Programming steps - alternative 1:
● Machining, counter-spindle
● Gripping
● Machining side
● Machining, main side
Programming steps - alternative 2:
● Machining, counter-spindle
● Complete transfer (gripping and machining side)
● Machining, main spindle
10.7.17.3 Programming example: Machining, counterspindle - without previous transfer
Programming steps
● Rear face
– Work offset
Work offset is only activated
– ZV:
Parameter is not evaluated.
● Machining, counterspindle
Programming technology functions (cycles)
10.7 Additional cycles and functions in ShopTurn
Turning
Operating Manual, 06/2019, A5E44903486B AB 651