Channel status
When required, channel messages are displayed in the status display.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
11.2.5 Editing the multi-channel program
11.2.5.1 Changing the job list
You now have the option to change the composition of the programs and/or the assignment of
the channel and program in a job list.
Precondition
● "programSYNC" option
Procedure
1. Select the "Program Manager" operating area.
2. Select where the multi-channel program should be archived
3. Position the cursor in the "Workpieces" folder on a job list and press the
"Open" softkey.
The window "Job list * JOB" is opened and the program assignment to
the channels is displayed.
4. Select the channel to which you wish to assign a new program and press
the softkey "Select program".
The "Program" window is opened and displays all of the programs cre‐
ated in the workpiece.
- OR -
Press the "Open job list" softkey.
Multi-channel machining
11.2 Multi-channel support
Turning
674 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
