Precondition
1. You have pressed the "Ctrl-E analyse" softkey and the "Ctrl-E analyse"
window has been opened.
2. You have already saved measurements.
Procedure
1.
Press the "Graphic" softkey.
2. Press the "Compare measurements" softkey.
Window "Ctrl-E Analysis": Compare" opens.
The power drawn and the recovered power of the actual measurement
are displayed in a bar diagram.
3. Press the "Saved measurements" softkey to compare the last 3 meas‐
urements that were saved.
4. Press the "Saved measurements" softkey again if you only want to see
the actual comparison.
21.2.7 Long-term measurement of the energy consumption
The long-term measurement of energy consumption is performed in the PLC and saved. The
values from times in which the HMI is not active are also recorded.
Measured values
The infeed and regenerative power values as well as the sum of the power are displayed for the
following periods:
● Current and previous day
● Current and previous month
● Current and previous year
Precondition
SENTRON PAC is connected.
Ctrl-Energy
21.2 Ctrl-E analysis
Turning
Operating Manual, 06/2019, A5E44903486B AB 919
To Next Page
Loading...
Need help?
General
