13.13 Changing the cutting edge position or tool type
Procedure
...
1. The tool list, the wear list, the OEM tool list or the magazine is opened.
2. Position the cursor in the column "Type" of the tool that you wish to
change.
3. Press the <SELECT> key.
The "Tool types - Favorites" window opens.
4 Press the <Cursor right> or <Cursor left> key to select the new cutting
edge position.
- OR -
Select the required tool type in the list of favorites or select using softkeys
"Cutters 100-199", "Drills 200-299", "Cutting tools 500-599" or "Special
tools 700-900".
5. Press the "OK" softkey.
The new cutting edge position or the new tool type is accepted and the
corresponding icon is displayed in the "Type" column.
Tool management
13.13 Changing the cutting edge position or tool type
Turning
762 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
Need help?
General
