Tool management
13
13.1 Lists for the tool management
All tools and also all magazine locations that have been created or configured in the NC are
displayed in the lists in the Tool area.
All lists display the same tools in the same order. When switching between the lists, the cursor
remains on the same tool in the same screen segment.
The lists have different parameters and softkey assignments. Switching between lists is a
specific change from one topic to the next.
● Tool list
All parameters and functions required to create and set up tools are displayed.
● Tool wear
All parameters and functions that are required during operation, e.g. wear and monitoring
functions, are listed here.
● Magazine
You will find the magazine and magazine location-related parameters and functions for the
tools / magazine locations here.
● Tool data OEM
This list can be freely defined by the OEM.
Sorting the lists
You can change the sorting within the lists according to:
● The magazine
● The name (tool identifier, alphabetic)
● The tool type
● The T number (tool identifier, numerical)
● The D number
Filtering the lists
You can filter the lists according to the following criteria:
● Only display the first cutting edge
● Only tools that are ready to use
● Only tools that have reached the pre-alarm limit
● Only locked tools
● Only tools with active code
Turning
Operating Manual, 06/2019, A5E44903486B AB 717
To Next Page
Loading...
Need help?
General
