Software option
You require the option "3D simulation (finished part)" for the simulation.
Changing the display
You can increase or decrease the size of the simulation graphic, move it, turn it, or change the
segment.
Displaying and moving cutting planes
You can display and move cutting planes X, Y, and Z.
See also
Defining cutting planes (Page 256)
7.5.5 2-window
Displaying a 2-window view
1. Simultaneous recording or simulation is started.
2. Press the "Further views" and "2 windows" softkeys.
The 2-window view contains a side view (left-hand window) and a front
view (right-hand window) of the workpiece. The viewing direction is al‐
ways from the front to the cutting surface even if machining is to be per‐
formed from behind or from the back side.
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as change
the segment.
Simulating machining
7.5 Different views of the workpiece
Turning
Operating Manual, 06/2019, A5E44903486B AB 247
To Next Page
Loading...
Need help?
General
