9.14 Selection of the cycles via softkey
Overview of the machining steps
The following machining steps are available.
All of the cycles/functions available in the control are shown in this display. However, at a
specific system, only the steps possible corresponding to the selected technology can be
selected.
⇒ ⇒
Drilling cycles only for turning/milling machine
⇒
⇒
⇒
⇒
Creating a ShopTurn program
9.14 Selection of the cycles via softkey
Turning
314 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
