Alarm, error and system messages
15
15.1 Displaying alarms
If the machine develops a fault in operation, an alarm is generated and machining is possibly
interrupted.
The error text that is displayed together with the alarm number gives you more detailed
information on the error cause.
You have the possibility of saving all of the relevant diagnostic data to a ZIP file, which you can
subsequently send to the hotline for analysis.
CAUTION
Dangers for persons and machines
Carefully check the system, based on the description of the active alarm(s). Resolve the cause
of the alarms. Then acknowledge the alarms in the specified way.
Failure to observe this warning will place your machine, workpiece, saved settings and
possibly even your own safety at risk.
Alarm overview
You can display all upcoming alarms and acknowledge them.
The alarm overview contains the following information:
● Date and time
● Cancel criterion
The delete criterion specifies the key or softkey that can be used to acknowledge the alarm.
● Alarm number
● Alarm text
Procedure
1. Select the "Diagnostics" operating area.
2. Press the "Alarm list" softkey.
The "Alarms" window appears.
All pending alarms are displayed.
The "Hide SI alarms" softkey is displayed if safety alarms are pending.
3. Press the "Hide SI alarms" softkey if you do not wish to display SI alarms.
Turning
Operating Manual, 06/2019, A5E44903486B AB 835
To Next Page
Loading...
Need help?
General
