Managing programs
14
14.1 Overview
You can access programs at any time via the Program Manager for execution, editing, copying,
or renaming.
Programs that you no longer require can be deleted to release their storage space.
NOTICE
Execution from USB-FlashDrive
Direct execution from a USB-FlashDrive is not recommended.
There is no protection against contact problems, falling out, breakage through knocking or
unintentional removal of the USB-FlashDrive during operation.
Disconnecting it during operation will result in the stopping of the machining and thus to the
workpiece being damaged.
Storage for programs
Possible storage locations are:
● NC
● Local drive
● Network drives
● USB drives
● FTP drives
● V24
Software options
To display the "Local drive" softkey, you require option "Additional HMI user
memory on CF card of the NCU" (not for SINUMERIK Operate on PCU50 or PC/
PG).
Turning
Operating Manual, 06/2019, A5E44903486B AB 775
To Next Page
Loading...
