Creating a G code program
8
8.1 Graphical programming
Functions
The following functionality is available:
● Technology-oriented program step selection (cycles) using softkeys
● Input windows for parameter assignment with animated help screens
● Context-sensitive online help for every input window
● Support with contour input (geometry processor)
Call and return conditions
● The G functions active before the cycle call and the programmable frame remain active
beyond the cycle.
● The starting position must be approached in the higher-level program before the cycle is
called. The coordinates are programmed in a clockwise coordinate system.
Turning
Operating Manual, 06/2019, A5E44903486B AB 259
To Next Page
Loading...
Need help?
General
