Abbreviation/program con‐
trol
Mode of operation
SKP Skip blocks are skipped during machining.
GCC When executing a jobshop program, it is converted into a G-code program.
MRD In the program, the measurement results screen display is activated while machining.
CST
Configured stop
Program processing stops at the points you defined as relevant to stop before the program
started. These may be, for example, especially critical points, at which you can check the
correctness of the sequence or exclude collisions.
You can specify NC functions (auxiliary functions, subprograms) and NC function transitions as
being stop-relevant.
As standard, the following conditions can be selected as relevant to stop in the "Program con‐
trol" window.
● Transition G0-G1
● Transition G1-G0
● Transition G0-G0
Note:
Please observe the information provided by the machine manufacturer.
Activating program control
You can control the program sequence however you wish by selecting and clearing the relevant
checkboxes.
Display / response of active program controls
If program control is activated, the abbreviation of the corresponding function appears in the
status display as feedback response.
Procedure
1. Select the "Machine" operating area.
2.
Press the <AUTO> or <MDI> key.
3. Press the "Prog. ctrl." softkey.
The "Program Control" window opens.
6.8.2 Skip blocks
You can skip program blocks that are not to be executed every time the program runs.
Machining the workpiece
6.8 Controlling the program run
Turning
174 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
Need help?
General
