19.5 Settings for teach-in
In the "Settings" window, you define which axes are to be included in the teach-in block and
whether motion-type and continuous-path mode parameters are to be provided.
Procedure
1. Teach-in mode is active.
2. Press the ">>" and "Settings" softkeys.
The "Settings" window opens.
3. Under "Axes to be taught" and "Parameters to be taught", select the
check boxes for the desired settings.
4. Press the "Accept" softkey to confirm the settings.
Teaching in a program
19.5 Settings for teach-in
Turning
902 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
