6.12.6 Displaying local user data (LUD)..........................................................................................210
6.12.7 Displaying program user data (PUD) ...................................................................................211
6.12.8 Searching for user variables ................................................................................................211
6.13 Displaying G functions and auxiliary functions.....................................................................214
6.13.1 Selected G functions ............................................................................................................214
6.13.2 All G functions ......................................................................................................................216
6.13.3 G functions for mold making ................................................................................................216
6.13.4 Auxiliary functions ................................................................................................................217
6.14 Displaying superimpositions.................................................................................................219
6.15 Mold making view.................................................................................................................222
6.15.1 Starting the mold making view .............................................................................................224
6.15.2 Adapting the mold making view ...........................................................................................224
6.15.3 Specifically jump to the program block.................................................................................225
6.15.4 Searching for program blocks ..............................................................................................226
6.15.5 Changing the view................................................................................................................227
6.15.5.1 Enlarging or reducing the graphical representation .............................................................227
6.15.5.2 Moving and rotating the graphic...........................................................................................228
6.15.5.3 Modifying the viewport .........................................................................................................228
6.16 Displaying the program runtime and counting workpieces...................................................230
6.17 Setting for automatic mode ..................................................................................................232
7 Simulating machining ...............................................................................................................................235
7.1 Overview ..............................................................................................................................235
7.2 Simulation before machining of the workpiece.....................................................................241
7.3 Simultaneous recording before machining of the workpiece................................................243
7.4 Simultaneous recording during machining of the workpiece................................................244
7.5 Different views of the workpiece ..........................................................................................245
7.5.1 Side view..............................................................................................................................245
7.5.2 Half section ..........................................................................................................................246
7.5.3 Face view .............................................................................................................................246
7.5.4 3D view ................................................................................................................................246
7.5.5 2-window ..............................................................................................................................247
7.6 Graphical display..................................................................................................................248
7.7 Editing the simulation display...............................................................................................249
7.7.1 Blank display ........................................................................................................................249
7.7.2 Showing and hiding the tool path ........................................................................................250
7.8 Program control during the simulation .................................................................................252
7.8.1 Changing the feedrate .........................................................................................................252
7.8.2 Simulating the program block by block ................................................................................253
7.9 Editing and adapting a simulation graphic ..........................................................................254
7.9.1 Enlarging or reducing the graphical representation .............................................................254
7.9.2 Panning a graphical representation .....................................................................................255
7.9.3 Rotating the graphical representation ..................................................................................255
7.9.4 Modifying the viewport .........................................................................................................256
7.9.5 Defining cutting planes.........................................................................................................256
Table of contents
Turning
Operating Manual, 06/2019, A5E44903486B AB 13
To Next Page
Loading...
