Figure 8-2 Parameter screen with help display
The animated help displays are always displayed with the correct orientation to the selected
coordinate system. The parameters are dynamically displayed in the graphic. The selected
parameter is displayed highlighted in the graphic.
The colored symbols
Red arrow = tool traverses in rapid traverse
Green arrow = tool traverses with the machining feedrate
Parameter screen with graphic view
Press the "Graphic view" softkey to toggle between the help screen and
the graphic view in the screen.
Creating a G code program
8.2 Program views
Turning
Operating Manual, 06/2019, A5E44903486B AB 263
To Next Page
Loading...
