Changes to the retraction plane therefore take effect when retracting from the previous
machining operation.
When selecting the traversing paths, the tool tip is always taken into account; i.e. the tool
expansion is not considered. Therefore, you should ensure that the retraction planes are an
appropriate distance away from the workpiece. The retraction planes refer to the workpiece. As
a consequence, they are not influenced by a programmable offset.
See also
Creating a new workpiece (Page 787)
Changing program settings (Page 312)
Programming the approach/retraction cycle (Page 322)
Creating a ShopTurn program
9.5 Creating a ShopTurn program
Turning
Operating Manual, 06/2019, A5E44903486B AB 299
To Next Page
Loading...
