Parameter Description Unit
Axes
(only for G code)
Selection of the participating axes:
● XY (1st and 2nd axis of the plane)
● ZC (rotary axis and assigned linear axis)
Note:
Rotary axes are only displayed in the selection field if they have been released for use in
the position pattern.
Please observe the information provided by your machine manufacturer.
X0
Y0
α0
R
N
Positioning
(only for G code)
Axes XY (at right angles)
X coordinate of the reference point (abs)
Y coordinate of the reference point (abs)
Starting angle for first position referred to the X axis.
Positive angle: Circle is rotated counter-clockwise.
Negative angle: Circle is rotated clockwise.
Radius
Number of positions
● Straight line: Next position is approached linearly in rapid traverse.
● Circular: Next position is approached along a circular path at the feedrate defined in
the machine data.
mm
mm
Degrees
mm
Z0
C0
N
(only for G code)
Axes ZC (G19)
Z coordinate of the reference point (abs)
Start angle of the C axis (abs)
Number of positions
mm
Degrees
Machining
surface
(only for Shop‐
Turn)
● Face C
● Face Y
● Peripheral surface C
● Peripheral surface Y
Position
(only for Shop‐
Turn)
● At the front (face)
● At the rear (face)
● Outside (peripheral surface)
● Inside (peripheral surface)
Position
(only for Shop‐
Turn)
Selection options for the following positions - (only for face C/Y)
● center
● off-center
Programming technology functions (cycles)
10.1 Drilling
Turning
398 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
