Procedure
1. The part program or ShopTurn program to be processed has been cre‐
ated and you are in the editor.
2. Press the "Milling" softkey.
3. Press the "Multi-edge spigot" and "Multi-edge" softkeys.
The "Multi-edge" input window opens.
Parameters in the "Input complete" mode
Parameters, G code program Parameters, ShopTurn program
Input
● Complete
PL Machining plane T Tool name
Milling direction D Cutting edge number
RP Retraction plane mm F Feedrate mm/min
mm/tooth
SC Safety clearance mm S / V Spindle speed or constant cutting
rate
rpm
m/min
F Feedrate *
Parameter Description Unit
Machining
surface
(only for Shop‐
Turn)
● Face C
● Face Y
Position
(only for Shop‐
Turn)
● Front
● back
(only for Shop‐
Turn)
Clamp/release spindle (only for face Y)
The function must be set up by the machine manufacturer.
Programming technology functions (cycles)
10.4 Milling
Turning
Operating Manual, 06/2019, A5E44903486B AB 521
To Next Page
Loading...
