Parameter Description Unit
Machining
surface
(only for Shop‐
Turn)
● Face C
● Face Y
● Peripheral surface C
● Peripheral surface Y
Position
(only for Shop‐
Turn)
● At the front (face)
● At the rear (face)
● Outside (peripheral surface)
● Inside (peripheral surface)
(only for Shop‐
Turn)
Clamp/release spindle (only for end face Y/peripheral surface Y)
The function must be set up by the machine manufacturer.
Machining
● ∇ (roughing)
● ∇∇∇ (finishing)
● Chamfering
Machining direc‐
tion
Machining in the programmed contour direction
● Forward:
Machining is performed in the programmed contour direction
● Backward:
Machining is performed in the opposite direction to the programmed contour
Radius compen‐
sation
● Left (machining to the left of the contour)
● Right (machining to the right of the contour)
● off
A programmed contour can also be machined on the center-point path. In this case,
approaching and retraction is only possible along a straight line or vertical. Vertical ap‐
proach/retraction can be used for closed contours, for example.
Slot side compen‐
sation
(only ShopTurn)
Slot side compensation on or off (only for machining surface, peripheral surface C)
D Offset to programmed path
- (only for slot side compensation on)
Programming technology functions (cycles)
10.5 Contour milling
Turning
Operating Manual, 06/2019, A5E44903486B AB 579
To Next Page
Loading...
