G code program parameters ShopTurn program parameters
Milling direction
● Climbing
● Conventional
D Cutting edge number
RP Retraction plane mm F Feedrate mm/min
mm/rev
F Feedrate * S / V Spindle speed or constant
cutting rate
rpm
m/min
Parameter Description
Machining
surface
(only for ShopTurn)
● Face C
● Face Y
● Face B
● Peripheral surface C
● Peripheral surface Y
(only for ShopTurn)
Clamp/release spindle (only for end face Y/B and peripheral surface Y)
The function must be set up by the machine manufacturer.
Machining The following machining operations can be selected:
● ∇ (roughing)
● ∇∇∇ base (base finishing)
● ∇∇∇ edge (edge finishing)
● Chamfering
Z0 Reference point in the tool axis Z mm
Z1 Pocket depth (abs) or depth referred to Z0 (inc) mm
CP
(only for ShopTurn)
Positioning angle for machining area - (only for machining surface, face Y)
Angle CP does not have any effect on the machining position in relation to the workpiece.
It is only used to position the workpiece with the rotary axis C in such a way that ma‐
chining is possible on the machine.
Degrees
C0
(only for ShopTurn)
Positioning angle for machining area - (only for machining surface, peripheral surface Y) Degrees
DXY
● Maximum plane infeed
● Maximum plane infeed as a percentage of the milling cutter diameter- (only for ∇ and
∇∇∇ base)
mm
%
DZ Maximum depth infeed - (only for ∇ and ∇∇∇ edge) mm
UXY Plane finishing allowance – (only for ∇, ∇∇∇ base and ∇∇∇ edge) mm
UZ Depth finishing allowance (only for ∇ and ∇∇∇ base) mm
FS Chamfer width for chamfering - (for chamfering only) mm
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering only) mm
* Unit of feedrate as programmed before the cycle call
Programming technology functions (cycles)
10.5 Contour milling
Turning
600 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
Need help?
General
