Parameter Description Unit
Lift mode Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height can be
programmed:
● To retraction plane
● Z0 + safety clearance
When making the transition to the next insertion point, the tool returns to this height. If
there are no elements larger than Z0 in the pocket area, Z0 + safety clearance" can be
selected as the lift mode.
mm
mm
FS Chamfer width for chamfering - (only for chamfering machining) mm
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering machining only) mm
Programming technology functions (cycles)
10.5 Contour milling
Turning
604 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
