3. Press the "Accept job list" softkey.
The name of the job list is entered in the field.
4. Press the "Accept" softkey.
CYCLE208 is taken over into the program. The name of the job list
is indicated in brackets.
Modify blank
Parameter Description Unit
Data for Here, you specify the spindle selected for the blank.
● Main spindle
● Counterspindle
Blank
The following blanks can be selected:
● Tube
● Cylinder
● Polygon
● Centered cuboid
● Delete
W Width of the blank - (only for centered cuboid) mm
L Length of the blank - (only for centered cuboid) mm
N Number of edges – (only for polygon)
SW or L Width across flats or edge length – (only for polygon)
ZA Initial dimension
ZI Final dimension (abs) or final dimension in relation to ZA (inc)
ZB Machining dimension (abs) or machining dimension in relation to ZA (inc)
XA Outside diameter – (only for tube and cylinder) mm
XI Inside diameter (abs) or wall thickness (inc) – for tube only mm
Procedure
1. The double editor is opened and the cursor is positioned in the G
code program.
2. Press the "Misc." and "Blank" softkeys.
The "Blank Input" window opens.
Multi-channel machining
11.2 Multi-channel support
Turning
676 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
