Synchronizing commands
Commands Meaning
START Starts another program
WAITM Sets a mark and waits for the specified channels (with exact stop)
WAITMC Sets a mark and waits for the specified channels (without exact stop)
WAITE Waits for the end of program of the specified channels
SETM Sets a mark
CLEARM Clears a mark
GET Fetches an axis
RELEASE Releases an axis
Note
Error identification when synchronizing the programs
The error can only be identified if the appropriate program is displayed. If a WAIT mark involves
a channel to which a program is not assigned in the job list, then this is marked as having an
error.
If you have enabled the synchronized view, then the following symbols are displayed at the top
right in the program title bar:
Symbol Meaning
Synchronized view: Error
Errors were identified after enabling "synchronized view" or new "synchro‐
nization" (e.g. WAIT marks not found in other programs).
Synchronized view: checked
No error was detected after enabling "synchronized view" or new "syn‐
chronization".
Multi-channel machining
11.2 Multi-channel support
Turning
688 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
Need help?
General
