Procedure
1. The tool wear list is opened.
2. Position the cursor on the disabled tool which you would like to reuse.
3. Press the "Reactivate" softkey.
The value entered as the setpoint is entered as the new tool life or work‐
piece count.
The disabling of the tool is cancelled.
Reactivating and positioning
When the "Reactivate with positioning" function is configured, the selected tool's magazine
location will also be positioned at a loading point. You can exchange the tool.
Reactivation of all monitoring types
When the "Reactivation of all monitoring types" function is configured, all the monitoring types
set in the NC for a tool are reset during reactivation.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
References
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Multiple load points
If you have configured several loading points for a magazine, then the "Load Point Selection"
window appears after pressing the "Load" softkey.
Select the required load point and confirm with the "OK" softkey.
Tool management
13.6 Tool wear
Turning
746 Operating Manual, 06/2019, A5E44903486B AB
To Next Page
Loading...
Need help?
General
