Simrad ST90 - Page 327

442703/B
325
Procedure
1Makethefollowingpreparations.
aOntheProcessorUnit,closeanyprogramsthatarerunning,andreturnto
thedesktop.
bInserttheEthernetswitchbetweentheOperatingPanelandtheProcessorUnit.
MakesurethatyouusethecorrectEthernetsocketontherearsideofthe
ProcessorUnit:ETH1
cInstallthesecondaryOperatingPanel.
dConnecttheOperatingPaneltoACmains.
eConnectthepowercablefromtheEthernetswitchtotheACpoweroutlet.
fDonot
connecttheOperatingPaneltotheEthernetswitch.
Ethernetcables
Tip
AnEthernetswitchconnectedtoETH1ontherearsideoftheProcessorUnitcanalso
beusedtointerfaceotherperipheralsystemssuchasechosoundersandpositioning
systems.YoucanalsoconnecttheOlexsystemtotheST90usingthisEthernetswitch.
2ChangetheIPAddressontheprimaryOperatingPanel.
Note
IfyouhavepreviouslychangedtheIPAddressontheOperatingPanel,youcan
proceedtothenextstep.
aOntheOperatingPanel,pressPower,andkeepitdepressedforafewseconds.
TheblueindicatorlightinthebuttonasheswhiletheOperatingPanel
establishescontactwiththeProcessorUnit.Whentheconnectionhasbeen
made,theblueindicatorlightislitpermanently.
bOntheProcessorUnitdesktop,openfolderSIMRAD-Shortcut.
Settingtowork