Simrad ST90 - Turning on the Transceiver Unit for the First Time

442703/B
281
eObservethatyourProcessorUnitisaddedtothelist.
fClosethewebbrowser.
5MakesurethattheOperatingPanelisfunctional.
aMakesurethattheblueindicatorislit,andcheckthatyoucanmovethe
cursoronthescreen.
bOntheProcessorUnitdesktop,double-clicktheST90icontostarttheprogram.
WaituntiltheST90operatesnormally.
cPressandholdPowerdepressedfourminimumfoursecondstoturnoffthe
OperatingPanel.
ObservethattheTransceiverOn/Offdialogboxopensautomatically.
MakesurethattheST90isturnedoff.
dTurnontheST90withthePowerbuttonontheOperatingPanel.
eMakesurethatyoucancontrolthecursor,andthatyoucanmakeselectionsin
themenusystem.
fPressand/orturnselectedbuttons,andmakesurethatthecorresponding
functionisactivatedintheuserinterface.
Relatedtopics
OperatingPaneldescription,page26
SecondaryOperatingPanel,page40
UsingasingleOperatingPaneltocontrolmorethanonesonar(Mk2),page320
UsingmorethanoneOperatingPaneltocontrolthesonar(Mk2),page324
TurningontheTransceiverUnitforthersttime
ToturnontheST90forthersttime,youmustrstturnontheProcessorUnit.When
theProcessorUnitandtheST90programisupandrunning,youcanturnonthe
TransceiverUnit.
Prerequisites
TheST90isinstalledasspeciedinthismanual.Y oumustbeequippedwithastandard
setoftools.
Context
HowtoturnontheST90fordailyuseisexplainedintherelevantend-usermanuals.
Procedure
1MakesurethatthecorrectACmainsvoltageisavailable.
2ConnecttheEthernetcablefromtheProcessorUnittotheTransceiverUnit.
3ConnecttheTransceiverUnittoACmains.
Settingtowork