Simrad ST90 - Page 374

372
442703/B
4OntheleftsideoftheInstallationdialogbox,selectInstallationParameterstoopen
thepage.
aOpentheMRU(MotionReferenceUnit)page.
bMakesurethattheinstallationparametersforthemotionsensor(offsetand
rotation)arecorrect.
Thephysicallocationofthesensor(X,YandZoffsets)mustbeextractedfrom
thedetailedvesseldrawings,orfromthereportsprovidedbythepersonnelthat
didtheactualinstallation.Theinformationabouttheinstallationanglesmust
beextractedfromthereportsprovidedbythepersonnelthatdidormeasured
uptheactualinstallation.
5ClosetheInstallationdialogboxwithoutmakinganychanges.
6Observethetopbar.
7Makesurethattheinformationfromthesensorisdisplayed.
Ifnecessary,enabletheread-outintheDisplayOptionsdialogbox.
Note
Inordertoreadthemotioncompensationvalues,theST90mustbe"pinging".
8Ifpossible,useanotherinstrumenttoverifythattheinformationprovidedbythe
ST90iscorrect.
9Fillintheresulttables.
Result
PortBaudrateProtocol
XOffsetYOffsetZOffset
RotationAroundXRotationAroundYRotationAroundZ
Requirements
Results
Motioncompensationisoperational.
Thecompensatedvaluesareshown.
Dateandsignature:
SimradST90InstallationManual