501
Software - Installation and basic settings 8
Installing the Stoll operating system
When the Stoll operating system is copied, two more program points are
displayed in the "Software update" window.
Software updating expanded window
"Software updating" expanded window
Other functions in the Software update window
Other functions in the "Software update" window
Reset update:
➜ Tap on the key "Reset update" (1).
The data is deleted in a separate storage location o
n the hard disk of the
machine.
Key
Function
1
The data in the separate memory area are deleted.
2
Selection of whether the installation should be executed
automatically or manually when the machine is switched on
next.
After a waiting time of 10 seconds the installation
is automatically carried out till the "Reference runs"
window (like in the case of "Installation"). Within
the waiting time the installation can be cancelled
by tapping on "Cancel".
Select this setting if only the operating system
should be updated.
Installation like in the case of "Installation and
Configuration".
Select this setting if machine d
ata has been
modified. For example after a gauge conversion or
if a special equipment has been assembled.
To Next Page
Loading...