X35 Monitor Air Seeder Setup
6.28
6. Refer to Figure 6.39. The Status column
should list "Aux CPU Enabled" under normal
operation for the main CM-40 ECU.
a. It will say "Enabled" for any additional
CM-40 ECU’s.
7. The "Disabled option" can be used if an ECU
(other than the main ECU) is not working
properly and it is still possible to continue to
operate with basic control.
a. You can disable other ECU’s to prevent the
communication alarm from appearing until
the issue is solved or the ECU is replaced.
b. The "Status" column should then be
switched back to enabled.
8. The "Replace option" can be used to re-detect
an ECU on the list with a new replacement
ECU.
9.
The
"Unassign option" can be used to clear the
ISO Name for an ECU on the list.
a. It can then be re-detected as another
ECU on the list for troubleshooting or to
continue to operate with basic control until
the issue is solved or the ECU is replaced.
i. This is required to use an ECU that
is already detected.
ii. Two ECU’s are not allowed to have
the same ISO Name.
10. The "Remove option" can be used to remove
an ECU off the list if it has been added in by
mistake and is not required.
Important
If detecting ECU’s for the first time, repeat
this whole procedure for the rest of the ECU’s
following the order listed in the chart shown.
Important
At the end all the ECU’s should have an ECU ISO
Name, and firmware version identified and will be
displayed in the summary table.
To Next Page
Loading...
