X35 Console Optional Equipment
13.7
7. Turn the Pack Master button ON or
OFF to engage or disengage the Pack Master
pressure. When ON, the button will be green,
when OFF it will be red.
Note
The main purpose of enabling Track Master is so
the drill lifts when the master switch is manually
turned off and the drill lowers when the master
switch is manually turned on.
a. In order for the Pack Master to engage,
the drill must be lowered on an un-seeded
portion of the map or ASC must be off.
b. Turning the Pack Master button OFF
while the openers are down, will leave
the openers down but remove the down
pressure.
i.
This state may be desired in a soft
spot in the field in order to ‘float’ the
openers while continuing to seed.
8. Turn the Track Master
ON or OFF to
set whether the Lift Master state will track the
master state or not.
a. If turned ON (green) then the drill position
will follow the master switch state.
i. If the master is ON, the drill will be
lowered unless the drill is manually
lifted.
ii.
If the master is OFF, the drill will be
lifted.
b.
If the master is turned OFF (red), then the
drill position is independent of the master
switch state.
To Next Page
Loading...
