Xerox Phaser 790 Documentation

5. Connecting to the network
Xerox Phaser 790
5–3
Supported network protocols and frame types
The Phaser 790 supports TCP/IP, IPX/SPX, and AppleTalk protocols
(rules that enable computers on a network to communicate with each
other). These protocols are supported on Mac OS, Windows, and
UNIX platforms. All can be simultaneously active. Workstations that
use other protocols can print through a server that uses one of the
protocols mentioned.
Printing through a Token Ring configuration (supports the TCP/IP and
IPX/SPX protocols) is an option that requires purchase and installation
of a Token Ring card in the server.
The following table lists supported protocols, printing services, frame
types and platforms:
Protocol Printing Services Frame Types Platforms
Novell IPX/SPX PServer (Printer Server)
Enables printing in
NetWare networks.
Can run in bindery and
NDS modes.
Supports up to 8
servers and an NDS
connection.
Ethernet 802.2
Ethernet 802.3
Ethernet_II
Ethernet SNAP
Token Ring
Token Ring SNAP
Windows NT
Windows 95/98
Windows 2000
TCP/IP LPD (Line Printer
Daemon), the standard
TCIP/IP printing
protocol
http protocols for web
pages
Enables printing in
TCP/IP networks using
LPR clients.
Supports direct socket
interface with port 9100.
Ethernet_II
Token Ring SNAP
Windows NT
Windows 2000
Solaris 2.4
SunOS 4.1.x
TCP/IP SMB (Server Message
Block), the nbt protocol
that supports Windows
Ethernet_II
Token Ring SNAP
Windows NT
Windows 95/98
Windows 2000
AppleTalk
PAP (Printer Access
Protocol)
Ethernet SNAP
(EtherTalk Phase 2
only)
Macintosh
Windows 2000

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English