Xerox Phaser 790 Documentation

Xerox Phaser 790
B–1
Print options
The print options provide you access to all the special features of the
Phaser 790. Print options can be specified in several places—in Printer
Setup, from the printing application, from ColorWise Pro Tools, from
the Command WorkStation and from Fiery WebSpooler.
The table in this chapter briefly describes each print option, gives its
default setting, and provides information on any constraints or
requirements in effect.
Where to set print options
• During Setup
Some settings are specified during Setup. For information on the
current default printer settings, check with the system
administrator or the printer operator.
• From applications
With the Adobe PostScript and PCL printer drivers, you can
specify job settings when you print a job. Refer to the chapter
Printing from the Windows workstations or Printing from the Mac
OS workstations for more information.
• From ColorWise Pro Tools
Refer to the chapter Using ColorWise Pro Tools to set the default
RGB Source Profile, CMYK Simulation Profile, Output Profile,
CMYK Simulation Method, and RGB Separation settings.
• Overrides from the Command WorkStation and Fiery WebSpooler
To change job settings from the Command WorkStation, double-
click a job to display the Properties dialog box. To change job
settings from Fiery WebSpooler, double-click a job to display the
Override Print Settings dialog box. For more information, refer to
the chapters Introduction to the Command Workstation and Using
Fiery WebSpooler.
B

Xerox Phaser 790 Specifications

General

Brand	Xerox
Model	Phaser 790
Category	Copier
Language	English