7. Performing the setup from the Printer Control Panel
Xerox Phaser 790
7–7
Specify network information
1. Press the Offline button and press the Menu button until the I/O
Port Setup option is displayed.
2. Press the Item/Enter button to display the following options.
Enter information as required:
• Ethernet—Off/On. (On is the default.) Select On to enable
Ethernet communication.
• Ethernet Speed—Auto Detect/10 Twisted Pair/10
AUI/100. (Auto Detect is the default.) Select Auto Detect to
detect the speed at which data can be transferred
automatically over the Ethernet network or, optionally, to
specify the speed and cabling of the Ethernet network.
• Parallel Port—Off/On. (On is the default.) In addition to
receiving print jobs over Ethernet, the printer can receive
jobs from a computer through the high-speed parallel port.
Select On to enable printing through the parallel port.
• I/O Timeout—5-300 Seconds. (30 seconds is the default.)
If the parallel port is On, use this option to specify how long
the printer waits without receiving data from the parallel port
before deciding that the current job is complete. During the
timeout, the printer cannot receive new jobs through the
parallel port, but it continues to receive network print jobs.
• Ignore EOF—Yes/No. (Yes is the default.) If the parallel port
is On, use this option to specify that the printer should ignore
end-of-file (EOF) messages in a file. To print PostScript files
in binary format (not ASCII), set this option to Yes. When the
option is set to Yes, the printer uses the value you entered
for the parallel port timeout to determine when it has
reached the end of the file.
To Next Page
Loading...
Need help?
General
