EasyManuals Logo

Xerox Phaser 790 Documentation

Xerox Phaser 790
542 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #202 background imageLoading...
Page #202 background image
10. Installing user software in a Windows 2000 environment
Xerox Phaser 790
10–24
Installing the user software for SMB printing
Use SMB or WINS printing if you do not have a Novell network.
Printing by this method enables printing from a workstation to a
particular print connection (hold, print, or direct) on the Phaser 790.
The following procedure assumes you have the TCP/IP protocol and
Client for Microsoft Networks installed.
To set up printing to a second or third print connection, repeat this
procedure for each and assign each printer a unique descriptive name
during the printer driver installation for subsequent identification
purposes.
1. If the system administrator has not already done so, go to the
printer and configure the Phaser 790 for SMB printing. Specify
whether to install the PostScript or PCL driver. Refer to the
chapter Performing the setup from the Printer Control Panel.
2. At the workstation, double-click the My Network Places icon to
display your network environment.

Table of Contents

Other manuals for Xerox Phaser 790

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox Phaser 790 and is the answer not in the manual?

Xerox Phaser 790 Specifications

General IconGeneral
BrandXerox
ModelPhaser 790
CategoryCopier
LanguageEnglish

Related product manuals